Table of Contents
Advertisement
CONNECTIONS
See page 3 for Connections.
@ CD player.
@ Tape decks.
@® Speaker system B (R).
@ Speaker system B (L).
© Speaker system A (L).
© Speaker system A (R).
@ Tuner
Video disc playter, VCR etc...
© Turntable.
@ Toan AC wall socket.
CONNECTING SPEAKER CORDS
1. Strip off the vinyl covering and twist the tip of
the wire core.
®
=
Twist the wire core.
2. Loosen the knob and insert the wire core into
the terminal hole.
3. Tighten the knob to fix the wire core in place.
NOTE:
Do not allow the wire core to protrude and touch other terminals or
wires. if the cores of different wires touch, damage may be caused
to your components.
Speaker Impedance
When
speaker
systems
are connected
to only one
of the
SPEAKERS A or B terminals, such speakers should have rated
impedance in the range of
4- 16Q.
When speakers are connected to both the A and B terminals, they
should have a rated impedance in the range of 8 — 32.
CONNECTING INPUT/OUTPUT CORDS
Left channel!
White plug
Right channel @
——__U
C C
Red plug
Connect the white plug to the L (left) side, and the red plug to the R
(right) side. Be sure to push the plugs in securely.
TO USE THE COMPONENT
CONNECTED
TO
THE ADAPTOR TERMINALS
1. Set the POWER switch to OFF.
2. Remove the two shorting bars from the ADPT
2 terminals.
@ OUT
@'"
.
Shorting bars.
NOTE:
Remove the shorting bars to connect a graphic equalizerto these
terminals. Always keep the bars inserted while the terminals are
not in use, and take care not to lose them.
A-858
Graphic equalizer
7
<ARE1 119>
E
Advertisement
Table of Contents
