Table of Contents
Advertisement
PANEL FACILITIES
@ PHONO SELECTOR switch
Set in accordance with the type of cartridge used in you turntable.
MM:
Set to this position when using a moving magnet cartridge, or a
MC (moving coil) cartridge with high output of 1 mV or more.
MC:
Set to this position when using a moving coil cartridge.
MM SUBSONIC/MC SUBSONIC:
Subsonic filter for moving coil or moving magnet cartridges to cut
ultraiow frequency noise less than 17 Hz generated when playing
@ warped record.
When using a high-output moving coil cartridge, set this switch to
MM or MM SUBSONIC.
@ VOLUME CONTROL
Use to adjust volume level.
NOTE:
This unit is equipped with a circuit that attenuates the effect of tone
and loudness controls at volume is turned up.
@ MUTING switch/indicator
Use to temporarily cut sound volume.
ON:
The indicator lights. The sound volume will be cut off.
OFF:
The indicator goes off. The sound will return to its previous volume.
@ INPUT SELECTOR switch
Use to select playback source,
LINE:
Set
to this position when
listening to the programs
from a
component connected to the LINE terminals.
TUNER:
Set to this position when listening to AM or FM broadcasts with a
tuner,
PHONO:
Set to this position
when
listening
to record
playback
on
a
turntable,
CD:
Set to this position when listening to a compact disc playback with
a CD player.
DAT/TAPE 1:
For playback with a tape deck or digital audio tape deck connected
to the DAT/TAPE 1 terminals.
TAPE 2:
For playback with a tape deck connected to the TAPE 2 terminals.
@® REC SELECTOR switch
Switch to select recording signal. When set at other than SOURCE
or OFF position, signals can be recorded during playback of the
equipment selected by INPUT SELECTOR switch.
TUNER:
To record from a TUNER.
CD:
To record from a CD player.
OFF:
In this position nothing from the REC terminals of DAT/TAPE 1 and
TAPE 2 will be output. Select it when not recording; output to tape
decks will be disconnected, improving sound quality.
SOURCE:
To record the equipment selected by INPUT SELECTOR switch,
TAPE:
12
To record (copy) from the tape deck of DAT/TAPE
1 terminals,
over to the tape deck of TAPE 2 terminals.
21
To record (copy) from the tape deck of TAPE 2 terminals, over to
the tape deck of DAT/TAPE 1 terminals.
NOTE:
The REC SELECTOR switch has no effect on the recording out put
of the ADPT 1/TAPE 3 terminals.
[REAR PANEL]
@ TAPE 2 PLAY terminals.
@ DAT/TAPE 1 PLAY terminals.
@ TAPE 2 REC terminals.
@ DAT/TAPE 1 REC terminals.
@ SPEAKERS B terminals (right channel).
@ SPEAKERS B terminals (left channel).
@ Power cord.
Connect this cord to an AC wall socket, or the AC outlet of an
audio timer.
@ SPEAKERS A terminals (left channel).
@ SPEAKERS A terminals (right channel).
6
<ARE1119>
E
@ ADPT 1/TAPE 3 OUT/REC terminals.
@ ADPT 1/TAPE 3 IN/PLAY terminals.
@ Shorting bars.
@ ADPT 2 IN terminals.
@ ADPT 2 OUT terminals.
@ PHONO terminals.
@ Turntable ground terminal! (GND).
@ LINE terminais.
@ TUNER terminals.
@ CD terminals.
Advertisement
Table of Contents
