Installation - Klarstein WONDERBEAM Manual

EN
20

INSTALLATION

Before assembly, make sure that all parts are complete and that the product is
undamaged.
If you wish to use the electric heater freestanding, please mount it using the feet
provided and follow the instructions below. Make sure the fan heater is mounted
on a flat, stable and clean surface.
Wall mounting
1. Remove the wall brackets and expansion bolts from the box. Hook and screw
the wall brackets to the holes on the back of the unit as shown in the figure
below.
2. Drill two holes, each 8 mm in diameter and 35 mm deep, in the wall as
shown in the figure below. The distance between the two holes must be
275,5/375,5/480,5 mm as in the table below.
3. Then insert the expansion bolts into the holes and screw tight, leaving 5
mm of length sticking out of each. Only 2 screws need to be attached to the
wall, the bottom bracket only plays a supporting role. No screws have to be
screwed in for this.
4. Align the holes on the wall bracket fixed to the wall at the upper part of the
back of the unit with the expansion screws, and hook the unit to the screws.
Move the device up and then to the left to slide the screws into the slot (see
image below).
Model (Power) Distance
10045437 (450 W) 275.5 mm
10045438 (650 W) 375.5 mm
10045439 (900 W) 480.5 mm