Viking Designer DUAR140 Use & Installation Instructions Manual page 8

T T O O M M A A T T C C H H E E X X I I S S T T I I N N G G C C A A B B I I N N E E T T R R Y Y T T O O E E K K I I C C K K H H E E I I G G H H T T
Min. 5/8" (1.7 cm)
Max. 3/4" (1.9 cm)
29 1/16"
(75.7 cm)
Mounting surface
(non-face) side
O O P P T T I I O O N N A A L L F F O O R R 4 4 " " T T O O E E K K I I C C K K
1/4" X 3/8" Deep hinge screw clearance hole. Locate and drill using
door hinge hole after the door has been aligned to the unit and when
the wood is positioned on door
14 15/16"
(36.4 cm)
7 5/32" (18.2 cm)
15/32" (1.2 cm)
23/32"
(1.8 cm) TYP
1 23/32" (4.4) cm min.
width to cover door
extrusion
23/32"
(1.8 cm)
Pre-drilled piolt holes -
places
1/4" X 3/8" Deep hinge screw clearance hole. Locate and drill using
door hinge hole after the door has been aligned to the unit and
when the wood is positioned on door
8
Mounting surface
(Non-face) side
7 13/16"
(19.8 cm)
TYP
15 5/32"
(38.5 cm)
TYP
22 1/2"
(57.2 cm)
TYP
Mounting surface
(non-face) side
TYP