Page 5
ual Fuel 30” and 36” W. Ranges ual Fuel 48” and 60” W. Ranges escription 30” W. Models 36” W. Models escription 48” W. Models 60” W. Models...
Page 6
( 0 . CAUTION Note: Minimum clearance for back wall is 0” with backguard or high-shelf. Note: If a range hood is installed, wall cabinets above the range have a different minimum clearance height. / C o o s i e r l ”...
Page 7
WARNING shall be used if required by NFP - 70 (National Electric Code), federal/state/local laws, or local ordinances. If the use of a GFI is required 2-3/4” (7.0 cm) 2” dia. (5.1 cm) Gas connection in this area 31-1/16” 23-7/16” (78.9 cm) (59.5 cm) 2-1/2”...
Page 9
Note: It is strongly recommended Note: Legs should be installed near to where that a pallet or lift jack be used rather than tilting. appliance is to be used, as they are not secure for long transit. Note: If you have a 4-wire connection, see following section for 4-wire connection instructions.
Page 10
WARNING WARNING Note: VDSC560 ranges contain two access doors and terminal blocks. Either location can be used for the power supply dependent on the receptacle location or length of power supply wiring.
Page 12
WARNING Y Y Y X X X r e m u r e u r e a s u ( 1 . ( 1 . ( 1 . / 2 ” / 2 ” / 2 ” u r e u r e u r e DANGER...
Page 13
Note: Standoff brackets can only be removed if range is installed against a NON-COMBUSTIBLE wall. DANGER Note: Arrow on burner cap must be pointing towards back of range. ” ” ” 3 / 8 3 / 8 3 / 8 ( 0 .