Technics SU-A900 Operating Instructions Manual page 6

(continued)
Connections
1 To connect to speakers ~
One pair of speakers can be connected to the "A" terminals of
this unit and one pair to the "B" terminals, or only one pair of bi-
wired speakers can be connected to all terminals.
(To connect main and/or second speakers )
(not Included)
■ toad Impedance
• When only the "A" or only the "B" terminals are used: 4-16
ohms
•When both the "A" and the "B" terminals are used
simultaneously: 8-16 ohms
( To connect bl-wlred speakers
(not included) )
Note:
Connect only bi-wired speakers in this way.
■ toad impedance
When bi-wlred speakers are used: 4-16 ohms
■ Bi-wIrlng
The treble range and the bass range of the speakers are con¬
nected to the speaker terminals of the amplifier by using two
speaker connection cords separately for each.
As a result of making connections In this way, sound can be
reproduced with much greater nuance and detail, with the feel¬
ings of air oscillation and deepness of sound provided by an input
source that suppresses reciprocal band-range interference.
(Refer to the operating instructions of the speakers.)
-To connect cords to terminals-
(D
Strip off the outer
CD
covering, and twist the g^=m
4
center conductor. 10 mm Twist
@ Turn completely to the (D
left.
® Insert the wire and turn completely to the right. Pull the
cord to assure a proper connection.
Note:
Be sure to only connect positive (+) cords to
positive (+) terminals, and negative (-) cords to
negative (-) terminals.
Note:
To prevent damage to circuitry, never
short-circuit the positive (+) and negative
(-) speaker wires.
-For United Kingdom only
When using banana plugs
Use with the speaker terminal
knob tightened completely.
Banana plug
(not included)
To connect the AC power supply cord
(Included)
FOR UNITED KINGDOM ONLY
BE SURE TO READ THE CAUTION FOR THE
AC POWER SUPPLY CORD ON PAGE 3
BEFORE CONNECTING THE AC POWER
SUPPLY CORD.
Connect the AC power supply cord (included) after ail other
cables and cords are connected.
(For areas except Australia and N.Z.)
Insertion ol Connector
Even when the connector Is perfectly
Inserted, depending on the type of in¬
let used, the front part of the connec¬
tor may Jut out as shown in the draw¬
ing.
However there Is no problem using the
unit.
Note:
The configuration of the AC power supply cord differs according
to area.
/"■Not supplied tor United Kingdom, Europe,-
Australia and NJZ.
If the power plug will not fit your socket, use the power plug
adaptor (included).