Page 1
LITTLE MARK III COMBO HEAD II SERVICE MANUAL 2009 EDITION...
Page 2
How to disassemble the LMIII / CHII preamp 1. Remove the six black knobs and the three yellow knobs pulling out as indicated in the picture (red arrow). 2. Remove the nine silver hexagonal nuts using a 10 or 11 mm nut screwdriver.
Page 3
How to disassemble the LMIII / CHII poweramp 1. Remove the four connectors (yellow arrows). 2. Cut the two ties (green arrows). 3. Remove the six screws (red arrows). How to disassemble the LMIII / CHII front panel components 1. Remove the two screws with a 2.5 mm hexagonal wrench (red arrows). 2.
Page 4
How to Disassemble the LMIII / CHII rear panel components 1. Remove the four hexagonal nuts using a 15 mm nut screwdriver (green arrows). 2. Using a screwdriver, remove the two screws of the line out jack and the two screws of the speaker out speakon combo jack (yellow arrows).
Effects Loop Modification The images below show how the effects loop in your amp can be modified to run in series. The default factory setting is parallel. PARALLEL CONNECTION REAR PANEL SECTION LMIII / CHII PREAMP SECTION SERIAL CONNECTION REAR PANEL SECTION LMIII / CHII PREAMP SECTION...
Need help?
Do you have a question about the LITTLE MARK III and is the answer not in the manual?
Questions and answers