Endon 106336 Installation And Safety Instructions

Safety Warnings

These instructions are for your safety. Please read through them thoroughly before use and retain them for future
reference. If you are in any doubt about installing this product, consult a qualified electrician.
This product is only suitable for connection to a 220-240V~ 50Hz supply. It is for indoor use only, and not
suitable for a bathroom location.
This fitting is a Class II, Double Insulated product and does not require an Earth. Live or Neutral must not be
connected to Earth.
Do not attempt to plug in or use this product until it has been fully assembled. Disconnect from mains during
assembly or maintenance. this product must be used on a stable, flat surface.
Under no circumstances must this floor lamp be covered with any material as this could pose a safety hazard.
This product is not suitable for persons under 14 years of age.
This product may contain delicate parts – be careful during handling and maintenance to avoid breakage.
The lamp must be protected by a 3 amp fuse in the mains plug.
Never fit bulbs of a higher wattage than those specified on the label as these may damage the fitting.
The lampshade part can be adjusted to an appropriate angle as needed.
Never put anything on the product or hang anything on any part of this product.
If the external flexible cable or cord of this luminaire is damaged, it must only be replaced by a qualified
electrician to avoid any electrical hazards.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or local store for recycling advice.

Care and maintenance

For bulb replacement, switch off the product (preferably, isolate it at the distribution board) and allow it to cool
down (Caution: bulb gets hot during use).
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.

Troubleshooting

When the bulb does not light after installation:
> Please plug in and operate the foot switch to turn your lamp on.
> Please check the bulb.
> Please check the 3 amp fuse in the plug and ultimately check the relevant fuse in your fuse box.
If you have any doubt about installation/use of this product, consult a qualified electrician.
To use this item in Europe, the 3 pin adaptor can
be removed by loosening the central screw and
removing the adaptor to reveal the 2 pin Europe
plug.
106336_07282023
Installation and Safety Instructions
Table Light
Converting 3 pin to 2 pin plug
1
2
BS 5733
3
BS 5733
BS 5733
UK Manufacturer: BH17 7BY
EU Manufacturer: Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg