Panasonic Omnivision PV-C2023 Operating Instructions Manual page 8

Please make all cable or antenna connections before power on.
For ANT./Cable
Connect the cable from Antenna/Cable
to the VHF/UHF terminal on the unit.
UNIT (rear view)
For DSS/Cable Box
Connect the OUT jack on your cable
box to the VHF/UHF terminal on the unit
with a RF cable.
WARNING: ....
Overtightening Nut type RF coaxial cables
may damage acks. F nger t ghten on y.
Press COMBO on the remote for Combo mode.
Plug the unit power cord into AC wail
outlet.
VHF/UHF
UNIT (rear view)
VHF/UHF
IN from
ANTJCABLE
Cable TV
Converter Box
IN from
ANTJCABLE
Press POWER on the remote or unit. The unit comes on and auto channel and
clock set starts.
• if you use a cabIs box, turn
it on and set it to the Public
Broadcasting Service (PBS)
channel in your time 7one.
If you use a DSS receiver, it
must be turned off.
If AUTO CLOCK SET IS INCOMPLETE screen
appears, set the clock using MANUAL CLOCK
SET procedure on next page.
Settings are made automatically. When
setup is done, this screen appears.
• Function buttons are inoperative during Initial
Setup.
• To remove a cassette during Auto Set, press
EJECT twice on the remote or STOP twice on
the unit. in this case, settings must be made
manually. (See page 10.)
• Depending on conditions, Auto Clock Set may
take longer than 30 minutes. If so, press STOP
to stop setup and perform settings manually.
(See page 10.)
• , . i tr_L'_I_IIiI_:TtTI]P.o1B_.'ICr.'_P,I_'-rd'_IRm'_I" . . • • = i - • •llllt_T=.]t_._-r•Taff_,re_J'. "