Cleaning, Care And Maintenance; Troubleshooting - Buffalo GF239 Instruction Manual

1. Connect the appliance to the mains power supply.
2. Place suitable cookware on to the centre of the glass plate.
Note: Never place empty cookware on the appliance.
3. Turn the dial to the desired power as indicated on the display.
4. If the pan is removed or the wrong type of pan is used, the appliance will make a beeping noise and
switch off after approximately 60 seconds.
Cleaning, Care & Maintenance
Isolate the power supply and allow the appliance to cool before cleaning.
• Use warm, soapy water and a damp cloth to clean the appliance.
• DO NOT use abrasive cleaners or pads.
• Dry thoroughly after cleaning.
• There are 2 removable air filters on the bottom of the appliance. Pull them out and clean with a
vacuum cleaner. Put back afterwards.

Troubleshooting

A qualified technician must carry out repairs if required.
Error Message
The unit is not The unit is not switched on
working
Lead is damaged
Mains power supply fault
Unit Beeps No pan or pan not suitable for
induction cooking
E01 Unit has overheated
E02 Pan being heated is empty,
temperature of pan is too high
E03 Power input has risen/fallen
below units operating limits
GF239_ML_A5_v4_20230614.indb 5 GF239_ML_A5_v4_20230614.indb 5
Probable Cause
Check the unit is hardwired correctly and
switched on
Replace lead
Check mains power supply
Use pan suitable for induction cooking such as
Vogue Stainless Steel Range
Ensure ventilation filter (located underneath
unit) is clean and unblocked. Allow unit to cool.
If error code still appears after unit has cooled
contact a Buffalo agent or qualified engineer.
Remove pan from unit. Allow unit to cool.
Ensure pan contains product to be heated. If
error code still appears after unit has cooled
contact a Buffalo agent or qualified engineer
Switch off unit. Allow unit to cool. If error code
still appears after unit has cooled contact a
Buffalo agent or qualified engineer
EN
Solution
5
2023/6/14 17:01 2023/6/14 17:01