Viking DVA-1003B Technical Practice

TECHNICAL
TECHNICAL
T
T
E L E
E L E
Model
DVA-2W
DVA-500A
DVA-1003B
DVA-3003
FBI-1A
I n s t a l l a t i o
I n s t a l l a t i o
A. DVA-2W Memory Expansion
Important: Electronics componants are sensitive to
static electricity. Personnel and the work area should
be grounded before handling.
1. Disconnect the power to the DVA-2W.
2. Remove the (2) screws on the bottom of the unit,
then remove the cover.
3. Insert the ERAM chip(s) carefully into the appro-
priate socket(s) with the indents facing in the dir-
ection shown in the diagram below.
4. Replace the cover and screws of the DVA-2W.
ERAM-60
VIKING ELECTRONICS
ERAM-60 REV B
S
S
C O M O L U T I O N S
C O M O L U T I O N S
Expand the Voice Record Time of
# of Kits Factory Record Time
up to 3 1 minute
1 16 seconds
up to 3 16 seconds per channel
up to 9 1 minute per channel
(3 minutes total)
1 16 seconds
n
n
Kit 2
P r a c
P r a c
2 1 C
2 1 C
F O R T H E S T
F O R T H E S T
Viking Products
The ERAM-60 Memory Expansion Kit is
designed to expand the voice record memory
of specified Viking products using non-volatile
memory.
Each kit includes one 28 pin non-volatile
memory chip which provides one minute of
Maximum Record Time
4 minutes
1 minute
1 minute
4 minutes per channel
(12 minutes total)
1 minute
S p e c
S p e c
Environmental: 0° C to 32° C (32° F to 90° F) with 5% to 95%
non-condensing humidity
Description: (1) 28-pin ERAM chip (1 minute of record time)
h t
h t
Kit 3
Kit 1
ERAM-60
ERAM-60
Memory Expansion Kit for
the DVA-2W, DVA-500A, DVA-
t i c e
t i c e
1003B, DVA-3003 and FBI-1A
E N T U R Y
E N T U R Y
record time. The num-
ber of chips required is
dependant
record time required
and the capacity of the
announcer.
i f i c a t i o n s
i f i c a t i o n s
P h o n e . .
P h o n e . .
t p : / / w w w . v i k i n g e
t p : / / w w w . v i k i n g e
May 7, 2001
on the
. 7 1 5 . 3 8 6 . 8 8 6 1
. 7 1 5 . 3 8 6 . 8 8 6 1
l e c t r o n i c s . c o m
l e c t r o n i c s . c o m