Advertisement
C
Use the COMBINER BOX to combine the DMX signal and the ARM signal.
ARM CONTROLLER
POWER
SOFTWARE SETTINGS
Make sure that the DMX/RDM settings on each SFX machine matches your wiring
setup. If the DMX signal runs separately over 5-pole XLR cables, make sure that XLR is
selected as DMX INPUT in the menu. If a combined DMX and ARM signal runs over
the ARM data (EtherCON) cables, make sure that ARM is selected as DMX INPUT in the
menu.
CORRECT DISPOSAL
MAGICFX
SFX SAFETY COMBINER BOX — User and Installation Manual
®
terminators
ARM
master
DMX CONTROLLER
This symbol on the product and / or accompanying documents means
that used electrical and electronic products should not be mixed with
general household waste. For proper treatment, recovery and recycling,
please take this product to designated collection points where it will be
accepted free of charge. Alternatively, in some countries you may be able
to return your products to your local retailer upon purchase of an
equivalent new product. Disposing of this product correctly will help save
valuable resources and prevent any potential negative effects on human
health and the environment, which could otherwise arise from
inappropriate waste handling. Please contact your local authority for
further details of your nearest designated collection point. Penalties may
be applicable for incorrect disposal of this waste, in accordance with your
national legislation.
insert
COMBINER BOX
DMX + ARM
slave
DMX
Advertisement
