Philips 27VM34 U Service Manual page 23

Index:
1. Rear Cover Removal
2. Serv e Position Main Panel ic
3. Side I/O Panel Removal
4. Rear Cover Mounting
Note: Figures can deviate slightly from the actual situation,due to different set executions.
4.1 Rear Cover Removal
1. Remove all fixation screws of the rear cover.
2. Now pull the rear cover backward and remove it.
4.2 Service Position Main Panel
1. Remove the main panel, by pushing the two center clips outward <1>. At the same time pull the panel away
from the CRT <2>.
2. Disconnect the degaussing coil and load speaker connector.
Move the panel somewhat to the right and flip it 90 degrees <3>, with the components towards the CRT.
①
4.3 Side I/O Panel Removal
1. Remove the complete Side I/O assembly after
unscrewing the 2 fixation screws [1].
2. Release the two fixation clamps [2] and lift the
board out of the bracket
4.4 Rear Cover Mounting
Before you mount the rear cover, perform the following checks:
1. Chec whether the mains cord is mounted correctly in its guiding brackets. k
2. Replace the strain relief of the AC power cord into the cabinet.
3. Chec whether all cables are replaced in their original position. k
5. Faultfinding and Test point w
Figure 4-2
aveform diagram
23--60
②
③