Advertisement
3. Software upgrade
Method 1:
1) Please ensure the software you are using has a correct file name
of panel is 1920*1080, the name should be TCL_MS19C_UPDATE_FHD.bin, if resolution
is 1366*768, file name should be TCL_MS19C_UPDATE.bin),
of USB disk.
2) Insert the USB disk to the USB socket of the set
3) Press Menu button of remote control, and select Contrast item of Picture submenu,
then press 1,9,5,0 consecutively, there you go the DESIGN MENU.
4) In DESIGN MENU, Go to the FACTORY MENU,select USB UPDTE item and press
the right button of remote
5
When prompt of "Update finished" show on the
screen, please do AC Power ON/OFF.
6) Enter the DESIGN $ M enu,then FACTORY MENU
again,and check the software information (Version/Date/
Product model) at the bottom of menu. If the project name is
not the one you wanted, you are recommended to change the Project ID as per following
" P roject ID selecting" procedure.
Method 2:
1) Please ensure the software file have correct file name
to the root directory of USB disk.
2) Insert the USB disk to the USB socket of the set
3) Press CH- button on key board and AC switch on the set at the same time. Wait for
10 seconds then release the CH- button to start upgrade
4 When prompt of "Update finished" show on the screen, please do AC Power
ON/OFF.
Notes: We recommend you use Method 1 to upgrade if the set can work properly. In some
circumstances, such as no picture, Method 2 could be an alternative.
procedure, power supply cannot be cut off. .
3.1 Project ID selecting
1) Press Menu button of remote control, then select Contrast item of Picture submenu;
press 1,9,5,0 consecutively, there you go the DESIGN MENU.
2) Select the SERVICE MENU item, press OK or RIGHT button of the remote to enter
the submenu;
3) Select the PROJECT ID item, press OK or RIGHT button of the remote to enter the
submenu;
4) Press RIGHT or LEFT button of the remote to select the ID you want.
5) After ID selection, press MENU button of the remote to exit DESIGN MENU.
6) Finally, do AC POWER ON/OFF.
control to start upgrade.
PRELIMINARY INFORMATION ----- SUBJECT TO CHANGE
12
MS19C
(If the resolution
copy it to the root directory
(Refer to Method 1),
During the upgrade
copy it
Advertisement
