First Qso - Kenwood TH-G71A Instruction Manual

FIRST QSO
The 7 steps given here will get you on the air CAUTION:
in your first QSO right away. So, you can @ THE Aegis ee een ae Is
j i j i 1 MINU ANI
enjoy the exhilaration that comes with 3 MINUTES OF RECEPTION. LONGER
OPERATION IN THE HIGH POWER MODE
MAY CAUSE THE BACK OF THE
TRANSCEIVER TO GET HOT.
@ TRANSMITTING WITH THE SUPPLIED
ANTENNA NEAR OTHER ELECTRONIC
EQUIPMENT CAN INTERFERE WITH THAT
EQUIPMENT. ALSO, TRANSMITTING NEAR
A REGULATED POWER SUPPLY, THAT IS
NOT RECOMMENDED BY KENWOOD, MAY
CAUSE THE POWER SUPPLY TO OUTPUT
AN EXTREMELY HIGH VOLTAGE. THIS
@ Press the PWR switch for 1 second or
| longer.
= —¥
_@ Turn the VOL control clockwise to the
| 11 o'clock position.
sie Diese poe ie
. © Press [BAND] to select the VHF or |
i ie Ak EQUIPMENT CONNECTED TO THE POWER
@ Turn the Tuning control to select a SUPPLY.
| irequency. : ; x Note: /f input voltage exceeds approximately 18 V,
¥ :
warning beeps sound and "DC ERR" appears on
@ Press and hold the PTT switch, then
speak in a normal tone of voice.
= 7 _ ate oe ¥- st al
_@ Repeat steps @ and @ to continue
[ communication. |
the display.
Note: When received signals are too weak to recognize,
press and hold [MONI] to hear clearer signals. You will,
however, also hear background noise.
ERRNO ient ma
5