CROSS-RC CZRJT4RTRY Manual

CAUTION
Safety Precautions
1.1 This radio-controlled model is not a toy, it is designed for persons 14 years of age or older.
1.2 Do not operate your vehicle on unsafe terrain; always pay attention to your surroundings.
1.3 Never operate your vehicle on public roadways, around moving people, animals, or operating machinery.
1.4 Keep clear of power lines and high-powered radio equipment to minimize radio frequency interference.
1.5 Since this vehicle contains small components, it may be a choking hazard for small children. Keep the vehicle and
any spare parts out of reach of small children.
Inspect your radio-controlled model before operation
2.1 Ensure that all screws are properly tightened. Use thread-lock to secure any metal to metal contacts- especially for components designed to withstand
torque (servo mounts, motor mount, drive shaft grub screws etc.).
2.2 Always check the battery voltage for both the transmitter and vehicle prior to operating your vehicle. Keep the batteries fresh in the transmitter and
always begin your vehicle runs with a fully charged battery pack.
2.3 Always check that the motor and servo are operating smoothly and in the right direction prior to operation. If binding between components is observed,
replace parts as necessary to reduce possibility of component or servo damage.
2.4 To turn on your vehicle, always power on your transmitter first, then power on your receiver.
After operating your radio-controlled model
3.1 To turn off the vehicle, always power off your receiver prior to powering off your transmitter.
3.2 Use caution when handling the vehicle- components, especially the ESC and motor which will be hot after operation.
3.3 Never use battery packs which are dented or otherwise damaged. Ensure that the wire insulation is intact and that connectors are properly soldered.
Lithium batteries can become fire hazards if mishandled.
TOOLS
(Not included)
2.5
1.5 2.0
Installation Reminder
1.Please read the manual carefully before installation.
2.The Electronic equipment to be purchased separately:
(1) .4 channels or above transmission and receiver * 1;
(2) .Steering servo 1;
*
(3). 25g Micro servo 2;
*
(4). ESC 1;
*
(5). Battery (size in 150 50
*
3.Motor gear range: M0.6, 10t-18T.
4.Application range: Brush motor 30t - 35t; Brushless motor 1400kV.
5.Screw sealant is only used between screw and metal parts.
6.Please don't install tires or leave the model above the ground When debugging the truck.
7.Please clean the surface first before paint to truck body. Keep it in a ventilated and safe environment and away from the fire source.
Electronic equipment
(Not included)
To prevent serious personal injury and/or property damage,operate all rKITtely
controlled models in a responsible manner as outlined herein.
40 mm).
*
4.0 5.5
1
ABS
CEMENT
7.0