Memorize Channel Manually - ViewSonic NextVision HD-12 User Manual

Memorize Channel Manually

● On the Channel menu page, select the third item
"Manual Scan", and then use the ◄ or ► button
to select the channel plan.
● Press Enter to highlight the input column. Then
press numeric buttons to input the channel
number. The channel frequency will be
automatically showing on right side of the input
column.
● Press Enter button when the message "Add
channel" and "press Enter to add channel" has
shown.
● If the ATSC signal is found and locked, the Status
will show message "Get No.XX 8VSB channel
success". Then you can press EXIT or Menu to
leave the menu page and watch the program, or
go ahead scanning the other channels.
● If the signal is not locked, the status will show
"Got No Channel". You can scan the signal again
or refer to the signal level bar "Signal" for aligning
the direction of the antenna to get the signal.
● When the signal is locked and the receiver is
on the channel, you can enter into this page to
check the signal level.
Note : It's suggested that you contact the antenna
Installer when you have to troubling with locking
the signal.
● Press EXIT button to back to the main menu or
press MENU button to leave.
21