Summary of Contents for Weston TZ0
- Page 1 Thru Zero Oscillator Eurorack Module User Manual Weston Precision Audio Designed In Portland, Oregon © 2023 Weston Precision Audio Revision 01 - September 25, 2023...
-
Page 2: Maximum Limits
Square*, Pulse frequency modulation and allows for (* = Directly from VCO core) additional sonic expression not available with standard linear FM. TZ0 Inputs (All inputs >=100kOhm is a 12 HP Eurorack module which is Impedance): 1 Volts/Octave, Linear available as a pre-built module or as a Frequency Modulation, FM Modulation DIY project. - Page 3 Frequency CV Modulation Section Input Changes oscillator See Page 3 for detail pitch on a 1 volt per octave scale. PWM Section See Page 4 for detail Primary Wave Outputs Sine, Triangle, Sawtooth, Square, Pulse © 2023 Weston Precision Audio...
- Page 4 FM. The “Lin FM” input on TZ0 is AC- The FM section of TZ0 is shown in the coupled. above block diagram. The “0Hz” point discussed above is simply adjusted with the “TZ Offset” knob. This has the side-...
- Page 5 PWM Section Sync The rightmost output on TZ0 is a PWM The oscillator core of TZ0 can be sync’d or pulse-width-modulated output. A pulse from another oscillator with the “Sync” signal with PMW is a square-shaped input. It is a “reset” or “hard” sync type signal that can vary its duty-cycle (the which resets the triangle’s integrating...
- Page 6 V/oct response for your particular case, MIDI converter, etc.. The following trimmer pots are located on the rear PCB of TZ0 and are labeled on the top side of the board with their function:...
-
Page 7: Revision History
REVISION HISTORY 01: Initial release. © 2023 Weston Precision Audio...