Sony TRINITRON KV-SP29M53K Service Manual page 78

d) If you wish to edit the channels, press
to change to edit mode.
Press b until the mode that you wish to edit
is highlighted: Label, Skip,
Then press
1) To label, press V or v to select the
alphanumeric characters for the label.
Then press
2) To skip the program number, press V or v to
select "On". Then press
You can skip this program number when
using PROG +/–.
3) To block unwanted program number,
press V or v to select . Then press
e) Repeat step b) to d) if you wish to change other
channels.
Press WEGA GATE to go to the next menu.
4
Press B or b to adjust the bars on the top
and bottom of the menu if they are
slanted, then press
"Picture V-Position" menu appears.
5
If the upper and lower bars are not
equally positioned to the top and
bottom of the screen, press V or v to
adjust them, then press
If no adjustment is necessary, then press
6
To prevent this "Initial Setup" menu from
appearing again when you turn on the TV
by pressing !, press V or v to select "No",
then press .
To allow this menu to appear again, select
"Yes", then press
Tip
• You can immediately go to the end of the "Initial Setup" menu by pressing WEGA GATE.
(block symbol).
.
.
.
.
.
.
Select
Select
.
Select
.
Select
Confirm Exit
Confirm Exit
Exit
Confirm
Select Confirm End
End
Select Confirm
Confirm
7
Installation