GRE PP032 Instruction Manual page 4

motor before working on the electrical connections.
• If it short-circuits, this will indicate there is an electricity problem. If it short-circuits
and cannot be restarted, ask a qualified electrician to verify and repair the electrical
system.
•The unit should be connected to an alternating current supply (see data on the
pump's plate) with an earth connection, protected by a residual current device (RCD)
with a rated residual operating current that does not exceed 30 mA.
• Unsuitable mains connections involve the risk of electrocution.
• The power supply should exactly correspond to the voltage indicated on the plate
of the motor. Incorrect voltage could provoke a fire and/or damage the motor, and
would cancel the guarantee. In case of doubt, check with an electrician.
• The electric cable is included and comes with a "Y" connection. If it is necessary to
replace the electricity cable, the new cable should also be of the appropriate type.
The guarantee will be cancelled in the case of any unauthorised modification of the
components.
• The electrical installation has to be according to current legislation.
• If the electrical cable is damaged, the manufacturer, its agent, or any other qualified
person should replace it to avoid any damage.
• The pump is equipped with complete thermal protection. Follow the assembly dia-
gram below for correct electrical installation.
• The electrical installation should be done by someone qualified in working with
electrical equipment. This device is not designed to be used by children, by physically
disabled persons or those with reduced sensorial or psychological ability or by per-
sons without experience or knowledge of the device, unless a persons responsible for
safety is in charge of their care and provides them with previous instructions for hand-
ling the device.
Do not permit children nor adults to sit or lean on the equipment. Children should be
supervised to ensure that they do not play with the equipment.
• Adjust the value of the thermal relay appropriately depending on the pump current.
• Unsuitable mains connections involve the risk of electrocution
4