Table of Contents
Advertisement
LUBRICATION TABLE
Point of Lubrication
Check
at
Hours
Change
at
Hours
Capacity
Anticipated Air Temperature
Above +32°F
+32°F to 0°F
Below 0°F
Engine crankcase
Check
before
each
use
50
3 pints
8 ounces
(1-3/4
quarts)
Cub Cadet
Low Ash
Engine Oil
SAE30
Cub Cadet
Low Ash Oil
SAE 10W-40
or 10W-30
Cub Cadet
Low Ash
Engine Oil
SAE 5W-20
or 5W-30
Hydro-drive unit
mounted on trans¬
mission case with
filter
Check
before
each
use
Add
as
needed
Approx.
14 pints
Cub Cadet
Hydraulic Transmission Fluid
NOTE:
Cub Cadet
hydraulic transmission fluid meets
IH B-6 specifications. If fluid is used that does not
meet these requirements, Cub
Cadet
will not be respon¬
sible for substandard performance. Failures due to use
of improper fluid are not covered by warranty. For
maximum protection, use
Cub Cadet
Hydraulic Trans¬
mission Fluid.
Steering knuckles &
front axle pivot bolt
10
Use 251H EP grease or equivalent No.2 multi-purpose
lithium grease and apply two or three strokes or suffi-
suffi-grease to flush out old grease and dirt.
Front wheel
bearings
30
Two or three strokes minimum of the lubricator using
251H EP grease or eqivalent No. 2 multi-purpose
lithium grease.
Alignment couplings
251H EP grease or equivalent No. 2 multi-purpose
lithium grease.
34
Advertisement
Table of Contents
