Toshiba 34HF85 Owner's Manual page 16

÷
÷
Using the remote controR
Preparing the remote controm for use
With the remote control, you can operate your TV, most cable TV
converters/satellite receivers, VCR and DVD player models together,
even if they are different brands, if you will be using your TV with a
Toshiba satellite receiver, VCR or DVD player, your remote controi is
already programmed and ready to use. if you own different brands of
cable TV converters/satellite receivers, VCRs and/or DVD players, you
first have to program your remote control. (See "Programming the
remote control for use with a cable TV converter/satellite receiver, VCR
or DVD player" on page 17.)
nstaHing the remote controm batteries
To install the batteries:
1. Open the battery cover on the back of the remote control.
2. Install two "AAA" size batteries. Match the + and - signs on the
batteries to the signs on the battery compartment.
3. Close the battery cover on the remote control until the lock snaps.
Using the remote eontrom to operate your
To controm a cable TV Power
converter/satellite Input (TV) --
receiver: Mute (TV) --
Channel
Program the remote Numbers --
control to recognize the CH RTN
brand of your cable TV (Channel R eturn)--
converter/sate!Iite receiver Channel A V
(see "Programming the CBL/SAT -- _, _. vo,
remotecontroItooperate Volurrle+/-(TV)-- _ _
your other devices" on Pic Size (TV) --
page 17.) The buttons
shown at right will control
the cable TV converter/
satellite receiver.
Press "CBL/SAT" first. TV/VCR -- _i
16
Nots:
7_heTV remote control may not operate your
VCR, DVD player, or cable TV converter.
Refer to the owner's manual supplied with the
appficab/e equipment to see which features
may be available. Additionatlx the remote
control for this TV may not support certain
features available on the odginaI remote
controls for such additional equipment, in
which case, it is suggested that you use the
original remote control for the appticabte
device.
Caution:
, Never throw batteries into a fire,
Notes:
, Be sure to use AAA size batteries.
, Disposeofbattedesinadesignateddisposa/area.
, Batteriesshould always be disposed of with the
environment in mind.Alwaysdispose of batteries in
accordancewithapplicable laws and regulations.
, tf the remote control does not operate correctly,
or if the operating range becomes reduced,
replace batteries wftb new ones.
, When necessary to replace batteries in the
remote control, always replace both batteries
with new ones. Never mix battery tyt_esor use
new and used batteries in combination.
, Alwaysremovebatteriesfromremote contmlif they
are dead or ff the remotecentre/is not to be usedfor
an extendedperiodof time.This will preventbattery
acid from leakinginto the batterycompartmenL
other devices
To controm a VCR:
Program the remote input (TV) --
controI to recognize Power --
Channel
the brand of your VCR Numbers --
(see "Programming the CH RTN
remote control to (Channel R eturn) --
operate your other VCR --
devices" on page 17.) Channel A_/ --
The buttons shown at Volume +/- (TV) --
right will then control Pic Size (TV) --
the VCR.
Press "VCR" first.
VCR controls --
ii_i i_!!i!i!i_!,ii,_ _i_i_i_i_:_ _:,!,!;_ii I
m.Jill!If
iiiii_ii ii
iiiiiiiiiiiil/_
ililililili:_ii_il
iiiiii_iiiiii/i
÷
J3U00121A(E) P16-23 16 _ 10/03/2005, 6:20 AM