Hints And Tips - Electrolux EW6F4943AP User Manual

12.13 Draining water out after end
of cycle
If you have chosen a programme or an option
that does not empty out the water of the last
rinse, the programme is completed, but:
• The time area shows
display shows the door locked
• The drum still turns at regular intervals to
prevent creases in the laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the Essorage button
to decrease the spin speed proposed by
the appliance.
2. Press the Départ/Pause
• If you have set Rinse Hold
appliance drains the water and spins.
• If you have set Night
only drains the water
The option indicator Rinse Hold
disappears.
3. When the programme is completed and
the door locked indicator
you can open the door.
4. Press the Marche/Arrêt button for a few
seconds to deactivate the appliance.

13. HINTS AND TIPS

WARNING!
Refer to Safety chapters.
13.1 The laundry load
• Divide the laundry into: white, coloured,
synthetics, delicates and wool.
• Follow the washing instructions on the
laundry care labels.
• Do not wash white and coloured items
together.
• Some coloured items can discolour with
the first wash. We recommend that you
wash them separately for the first couple
of times.
• Turn multilayered fabrics, wool and items
with printed illustrations inside out.
26 ENGLISH
12.14 Stand-by option
The Stand-by function automatically
deactivates the appliance to reduce the
energy consumption when:
• You do not use the appliance for 5
and the
.
• 5 minutes after the end of the washing
If the dial is rotated to the "Reset" position
button:
the appliance automatically turns off in 30
the
seconds.
the appliance
If you set a programme or an option that
ends with water in the drum, the Stand-
and Night
by function doesn't deactivate the
appliance to remind you to drain the
water.
goes off,
• Pre-treat stubborn stains.
• Wash stubborn stains with a special
• Be careful with curtains. Remove the
• A very small load can cause balance
• Button up pillowcases, close zippers,
minutes when no programme is running.
Press the button Marche/Arrêt to activate
the appliance again.
programme.
Press the Marche/Arrêt button to activate
the appliance again.
The display shows the end of the last
programme.
Turn the programme dial to set a new
cycle.
detergent.
hooks and put the curtains in a washing
bag or pillowcase.
problems with the spin phase leading to
excessive vibration. If this occurs:
a. interrupt the programme and open the
door (refer to "Daily Use" chapter);
b. manually redistribute the load so that
the items are spaced evenly around
the tub;
c. press the Départ/Pause button. The
spin phase continues.
hooks and poppers. Tie up belts, cords,
,