Garden Treasures F41075CA Quick Start Manual

Unpack all parts from Styrofoam and bubble warp inside the carton to ensure there are no missing or damaged parts. If any parts are missing or
damaged, do not attempt to assemble or use the product. Please contact customer service for replacement.
Part
Vase
Basin
Plastic Connector
Pump
Pebbles

Warnings and Cautions

Warnings:
•
To reduce the risk of electric shock, connect pump only to a Ground Fault
Circuit Interrupter (GFCI) outlet.
•
Do not exceed the voltage shown on the pump.
•
Always disconnect the pump from the power source before performing any
maintenance or work on the pump or fountain.
•
Inspect the power cord for damage before installation and/or maintenance.
Replace the entire pump if damage is found.
•
Do not remove the grounding pin from the power cord on pumps with a three-prong, grounded-type plug.
Cautions:
•
Do not install the fountain within 10 ft. (3.05 m) of a pool or spa. If the pump is connected to a Ground Fault Circuit Interrupter (GFCI) protected
circuit, the fountain can be installed no less than 5 ft. (1.52 m) from a pool or spa.
•
Use the pump only with portable, self-contained fountains no larger than 5 ft. in any dimension.
•
Use a proper power source as indicated on the pump label. Keep the cord away from high temperatures and/or heat sources.
•
Do not lift the pump by its power cord.
•
Keep the fountain out of reach of children.
•
Do not let the pump run dry. Pump should be completely submerged for proper operation and cooling. This pump (120Vac, 60Hz) is installed with
Thermal cutoff device. Thermal cutoffs are non-resetting type, thermally-sensitive devices that are designed to protect electrical appliances and
industrial equipment from fire. When this pump does run in abnormal conditions or dry conditions without water, the temperature of pump body
raises over safety point in which the thermal protector's cut off point is triggered. The thermal protector will break the electrical circuit and prevent
pump body overheat damage. When the temperature of pump body is cool to certain value of reseat of thermal protector, the thermal protector will
restore and the circuit will be closed again, so this pump will restart to operate. This protection function of pump can cut off and restart this pump in
periodical cycle.
•
Do not pump heated liquids.
•
Operate with freshwater only. Avoid heavily chlorinated water and water with high pH levels.

Preparation

Before beginning assembly, read all warnings and safety precautions. Remove parts from carton. Compare parts with parts list. If any part
is missing or damaged, do not attempt to assemble or use the product. Contact customer service for replacement.
Item # 247682
VASE FOUNTAIN
Model # F41075CA
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Quantity
1 pc
1 pc
1 pc
1 pc
1.5 kg
Questions, Problems, Missing Parts? Before returning to retailer, call
our customer service department at 866-728-6187 from 9 a.m. – 5 p.m.
EST, Monday – Friday, or e-mail customerservice@srg-usa.com.
NOTE: Diagram shown is for illustrative purposes only.
1