Garden Treasures F11434AA Quick Start Manual

Unpack all parts from the carton to ensure there are no missing or damaged parts. If any parts are missing or damaged, do
not attempt to assemble or use the product. Please contact customer service for replacement.

PARTS LIST:

Part# Description
01. LED Ring Light
02. LED Light cord
03 Light Cord Hole
04 Rubber Stopper

Warnings and Cautions

Warnings:
•
To reduce the risk of electric shock, connect pump only to a Ground Fault Circuit Interrupter (GFCI) outlet.
•
Do not exceed the voltage shown on the pump.
•
Always disconnect the pump from the power source before performing any maintenance or work on the pump or fountain.
•
Inspect the power cord for damage before installation and/or maintenance. Replace the entire pump if damage is found.
•
Do not remove the grounding pin from the power cord on pumps with a three-prong, grounded-type plug.
•
Assemble your fountain in the location you intend to use it. Do not move with water in the fountain
Cautions:
•
Do not install the fountain within 10 ft. (3.05 m) of a pool or spa. If the pump is connected to a Ground Fault Circuit Interrupter (GFCI) protected
circuit, the fountain can be installed no less than 5 ft. (1.52 m) from a pool or spa.
•
Use the pump only with portable, self-contained fountains no larger than 5 ft. in any dimension.
•
Use a proper power source as indicated on the pump label. Keep the cord away from high temperatures and/or heat sources.
•
Do not lift the pump by its power cord.
•
Keep the fountain out of reach of children.
•
Do not let the pump run dry. Pump should be completely submerged for proper operation and cooling. This pump (120Vac, 60Hz) is installed with
Thermal cutoff device. Thermal cutoffs are non-resetting type, thermally-sensitive devices that are designed to protect electrical appliances and
industrial equipment from fire. When this pump does run in abnormal conditions or dry conditions without water, the temperature of pump body raises
over safety point in which the thermal protector's cut off point is triggered. The thermal protector will break the electrical circuit and prevent pump
body overheat damage. When the temperature of pump body is cool to certain value of reseat of thermal protector, the thermal protector will restore
and the circuit will be closed again, so this pump will restart to operate. This protection function of pump can cut off and restart this pump in
periodical cycle.
•
Do not pump heated liquids.
•
Operate with freshwater only. Avoid heavily chlorinated water and water with high pH levels.

Preparation

Before beginning assembly, read all warnings and safety precautions. Remove parts from carton. Compare parts with parts list. If any part is missing or
damaged, do not attempt to assemble or use the product. Contact customer service for replacement.
Estimated time for assembly is 15 minutes.
TOOLS REQUIRED FOR ASSEMBLY:
No Tools needed
Vendor Item # F11434AA
Buddha Fountain
Questions, Problems, Missing Parts? Before returning to retailer, call our customer service
department at 866-728-6187 from 9 a.m. – 5 p.m. EST, Monday – Friday, or e-mail
Hcustomerservice@srg-usa.comH.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Quantity Part# Description
1 05 Buddha Statue
1 06 Water Supply Tube
1 07 Water Pump
1 08 Base
Quantity Part# Description
1 09 Transformer
1 10 Pump Cord
1 11 LED Light Output pin
1 12 LED Light Input Cord
Quantity
1
1
1
1