Mitsubishi Electric Mr. SLIM PKA-M KAL Series Installation Manual page 16

6. Electrical work
Service menu
Test run
Input maintenance info.
Settings
Check
Others
Main menu:
Cursor
F1 F2 F3
Fig. 6-2
Function setting
Ref. address
Unit No.
Grp./1/2/3/4/All
Monitor:
en Cursor Address
F1 F2 F3
Fig. 6-4
Function setting
Ref. address Grp.
Mode 1 1
Mode 2 2
Mode 3 1
Mode 4 1
Request:
Value
F1 F2 F3
Fig. 6-6
Note:
• Make the above settings on Mr. Slim units as necessary.
• Table 1 summarizes the setting options for each mode number. Refer to the indoor unit Installation Manual for the detailed information about initial settings,
mode numbers, and setting numbers for the indoor units.
• Be sure to write down the settings for all functions if any of the initial settings has been changed after the completion of installation work.
14
Settings menu
Function setting
Rotation setting
Service menu:
Cursor
F4 F1 F2 F3
Fig. 6-3
Function setting
Ref. address
Mode 1 1
Mode 2 2
Mode 3 1
Mode 4 1
Save:
Cursor
F4
F1 F2 F3
Fig. 6-5
Function setting
(1/8)
Ref. address Grp.
Sending data
F4 F1 F2 F3
Fig. 6-7
6.2. Function setting
6.2.1. Function setting on the unit (Selecting the unit functions)
1 (Fig. 6-2)
• Select "Service" from the Main menu, and press the [SELECT] button.
• Select "Settings" from the Service menu, and press the [SELECT] button.
2 (Fig. 6-3)
• Select "Function settings" with the [SELECT] button.
F4
3 (Fig. 6-4)
• Set the indoor unit refrigerant addresses and unit numbers with the [F1]
through [F4] buttons, and then press the [SELECT] button to confirm the
current setting.
<Checking the Indoor unit No.>
When the [SELECT] button is pressed, the target indoor unit will start fan operation.
If the unit is common or when running all units, all indoor units for the selected
refrigerant address will start fan operation.
Grp. (1/8)
4 (Fig. 6-5)
• Toggle through the pages with the [F3] or [F4] button.
• Select the mode number with the [F1] or [F2] button, and then press the
Page
[SELECT] button.
5 (Fig. 6-6)
F4
• Select the setting number with the [F1] or [F2] button.
Setting range for modes 1 through 28: 1 through 3.
Setting range for modes 31 through 66: 1 through 15.
6 (Fig. 6-7)
• When the settings are completed, press the [SELECT] button to send the
setting data from the remote controller to the indoor units.
• When the transmission is successfully completed, the screen will return to the
Function setting screen.
F4