Mac Filter - Casa Systems CFW-4221 User Manual

MAC Filter

MAC Filter allows you to add or remove the MAC Address of devices which will be allowed or denied access
to the wireless network. First use the Wireless Interface drop-down list to select the wireless network you
wish to configure, then change the MAC Restrict Mode setting from Disabled and select to either Allow or
Deny access to the MAC addresses listed.
The gateway offers the ability to use MAC Address filtering on ATM PVCs. You can elect to block or allow
connections based on MAC Address criteria. The default policy is to allow all connections.
Push the Enable/Disable button to the right to activate MAC filtering on the gateway.
I t e m D e s c r i p t i o n
Deny Access Change model
MAC name
MAC address
Save button
1 Enter the Protocol type to which the filter should apply.
2 Enter the Source and Destination MAC Address.
3 Enter the Frame Direction of the traffic to filter.
4 Select the WAN interface to which the filter should apply.
Click Apply/Save to save the new MAC filtering configuration.
CFW-4221/4222 – User Guide
UG01433 v1.03 November 2022
Figure 44 –MAC Filter list
Figure 45 – MAC Filter settings
© Casa Systems 2022
39 of 64