Quick Installation - ViewSonic Optiquest PF775 User Manual

Quick Installation

1 Connect video cable
Make sure both the monitor and the
computer are powered OFF. Connect the
video cable to the computer.
Macintosh
Macintosh adapter to the video cable,
then to the computer. To order a
Macintosh adapter, send an email to
E
vsparts@viewsonic.com or call
N
ViewSonic
G
back cover of this guide). You will need to
L
provide your monitor's serial number.
I
S
2 Connect power cord
H
Connect the power cord to a properly
grounded AC outlet, then to the monitor.
3 Power-ON monitor and computer
Power-ON the monitor, then power-ON
the computer. This sequence (monitor
before computer) is very important.
NOTE: At this point Windows
may receive a message asking them to
install the PF775's INF file.
4 Install INF and ICM files
• For CD-ROM: Insert the CD-ROM
into your system, wait for it to auto-
start, select "Monitor Drivers," and
follow the on-screen instructions.
• For diskette: Insert the diskette into
your system, run install.exe, and
follow the on-screen instructions.
Getting Started
6
® users: Connect a
® Customer Service (see the
®
98 users
Power cord
Video cable
5 Windows users: Setting the
Timing Mode (
resolution and refresh
rate) Example: 1024x768@ 75Hz.
For instructions on changing the resolu-
tion and refresh rate, see the user guide
for your computer's graphics card.
Use the OnView ®
6
adjust the screen image.
See the Operations section in this
guide.
Installation is complete!
Enjoy your new PF775 Monitor!
To be best prepared for any future
customer service needs:
• Write the serial number (see back
of the monitor) in "For your Records"
on page 1 of this guide.
• Register the warranty of your monitor
on the Internet at:
http://www.viewsonic.com
controls to
Monitor
Video port
(D-sub)
Computer
ViewSonic PF775