Advertisement
Subcarrier
Phase
Position of
Switches
23
Subcarrier Phase Coarse Switches
(SC, 1/2/3/4)
The subcarrier phase of the camera signal can be
adjusted from 0° to 360° in 90° steps with these
switches, as shown below, for matching the phase
of the subcarrier signal at the Gen-Lock Input con-
nector (9).
These switches should be set when the camera
is used in a system configuration with the Special
Effects Generator.
24
Subcarrier Phase Fine Control (SC PHASE)
This control allows fine adjustment of the subcarrier
phase set by the Subcarrier Phase Coarse Switches
(23). The control allows continuous control of up to
+90° subcarrrier phase to match the phase of the
subcarrier signal obtained at the Gen-Lock Input
connector (9).
25
26
27
Vertical Phase Control (V PHASE)
(For WV-CL500 and WV-CL504E)
The vertical
phase
of the camera
signal can
be
adjusted to match the vertical phase of the power
line at the power Cord (13) or AC 24V In Terminal
Strip (15).
Horizontal Phase Control (H PHASE)
The horizontal phase of the camera signal can be
adjusted to match the horizontal phase of the signal
at the Gen-Lock Video Input Connector (9).
Auto Iris Level Control
(ALC LEVEL, L (low)/H (High))
This control adjusts the control level of the auto iris
control when the lens selection switch (7) is set to
the DC position and the auto iris lens which requires
the DC control voltage such as WV-LA12
etc., is
mounted on the camera.
Note:
Adjust this contro! while setting the AGC
ON/OFF Switch (8) to OFF position.
Advertisement
