Table of Contents Introduction What’s Included Tools & Items About the Reusable Bracket Installing the Wings Placing the Bracket Cutting the Hole Uninstalling the Bracket Technical Assistance Warranty Return Process...
Introduction Thank you for purchasing the REBR Reusable Bracket. At Origin Acoustics, we take pride in providing you with a high quality product. All of Origin Acoustics’ speakers are designed to have excellent sound quality, longevity, and a simple installation process.
Nail About the Reusable Bracket Our reusable installation bracket (REBR68) is designed to be used as a new construction bracket for our Director 6 and 8” speakers. Additionally, the center plastic ring can be removed once the sheet rock has been cut to accommodate our speaker.
1. Installing the Wings Once desired speaker location is found, locate desired wing positions on the reusable bracket that coordinate with the ceiling joists for a secure fit. Line up and place the four pins of the bracket to the four holes of the wing. Attach Wing Bracket the wings by locking in place with the...
3. Cutting the Hole Make sure the “lip” of the reusable bracket is facing down into the room. The “lip” allows the bracket to act as a template for cutting the speaker cutout in the sheet rock. Cut along the inside of the bracket hole where the hole should be. Use a keyhole or drywall saw to cut the hole.
4. Uninstalling the Bracket To remove the bracket, squeeze the metal clips to loosen each wing. The wings can be cut if needed. They will not be used again. Once the wings are detached, unsnap the bracket at the joint to allow the bracket to bend for easy removal through the cutout.
If you are considering returning the product, it’s required that you contact Origin Acoustics prior to any return attempts. This way we can determine if the issue can be resolved without returning the product, or if needed we can provide instructions and support for the return process.
If the product is determined to be defective, it will be repaired or replaced at Origin Acoustics’ discretion. If the product must be replaced yet it is no longer manufactured, it will be replaced with a model of equal to or greater value that is the most similar to the original.
Before making any return attempts, it is required that you first contact Origin Acoustics. Return product to Origin Acoustics or your dealer, either in person or by mail. It’s preferable if the product is returned in the original packaging. If this isn’t possible, the customer is responsible for insuring the shipment for the full value of the product.
Need help?
Do you have a question about the REBR68 and is the answer not in the manual?
Questions and answers