Origin Acoustics FMKD68RD Quick Start Manual

FLUSH MOUNT BRACKETS

FLUSH MOUNT BRACKET
FMKD68RD - Round | FMKD68SQ - Square
Fits 6" & 8" Director Series Speakers
Flange
Mounting Holes
1) CUT Cut out ceiling hole using the included Cut-Out Template.
(Sizes as follows: 10
2) INSERT Insert the flush mount kit within in-ceiling hole, and ensure it sits flat
against the drywall.
3) CLAMP Use a Philips screw driver to turn the screw inside each clamp. This
will tighten the clamps and secure the bracket against the drywall.
4) SCREW Use a screwgun/drill to drive drywall screws through the mounting
holes of the flange, to secure the fluhsmount bracket into the drywall.
5) DRYWALL Apply joint compound over the bracket to seal and blend the
bracket into the ceiling.
6) FEATHER OUTWARDS Begin applying the joint compound 6 - 8 inches
(152 - 203 mm) from the bracket edge and then feather outward 16 - 20 inches
(406 - 508 mm) to achieve a smooth and flat transition.
7) INSERT BAYONET RING & DIRECTOR SPEAKER
Please visit docs.originacoustics.com or scan this QR code using your smart device for the
most up to date safety information and use instructions for this product.
Clamps
SPKA-FMKT-IC6-IC8
SCALE:1:2
''
5/16 (262MM) ROUND |
A
*All warranties and warranty conditions are subject to change. Please
refer to docs.originacoustics.com for the latest information.
Clamps
10 '' 10
1/8 (257MM) X
D
Flange
Mounting Holes
SPKA-FMKT-IC6-IC8-SQ
SCALE:1:2
''
1/8 (257MM) SQUARE
B
C
)