Table of Contents
Advertisement
Setting up cable
box control
(Skip this section if you are
using Hookup 2, 3, 4 or 6.)
Your VCR includes a cable box control
feature that allows the VCR to control most
brands of cable boxes / DSS receivers via an
' optional Cable Mouse.
With cable box
control, the VCR controls channels on the
cable box / DSS receiver for timer
recording. You can also use the VCR's
remote commander to change channels on
the cable box / DSS receiver whenever the
cable box/ DSS receiver is turned on even if
the VCR is turned off. To use cable box
control, you need to connect the Sony RM-
CM101 Cable Mouse (not supplied) (pages
10 and 22) and set the code number and
output channel.
This VCR is programmed with codes
necessary to control channel selection on
most brands of cable boxes at the time this
VCR was manufactured. It is possible that
new cable boxes may be introduced that
cannot be controlled with the RM-CM101
Cable Mouse. If you have a cable box that
is incompatible with this VCR, contact
your cable operator — they may be able to
provide you with a compatible cable box.
Number
buttons
ay
=
J
©
7
w~
CH+/-
g
©
t+
MENU
OK
tit/i—/—>
Press MENU, then press #/ to move the
cursor (») to CABLE BOX CONTROL and
press OK.
When using the EASY SET UP procedure,
skip this step.
CABLE BOX CONTROL
CABLE MOUSE
ON
*OFF
USE
</>»
TO SELECT
PUSH MENU TO QUIT
Press 4*/
to select ON.
"..-" flashes in the BOX CODE NO. row.
If a code number has already been
entered, press $ to select BOX CODE NO.
CABLE BOX CONTROL
CABLE MOUSE
»BOX CODE NO.
BOX OUTPUT CH
ENTER YOUR CABLE BOX
CODE NO. USING 0-9 KEYS
REFER TO THE OPERATING
MANUAL FOR THE CODE
continued
Getting Started | 31
Advertisement
Table of Contents
