Advertisement
BL-PSTG Pull-String Utility Light Owner's Manual
Battery Installation
1. To open, when looking at the back, twist the back cover
counter-clockwise and remove.
2. Insert 4 AA batteries (follow the installation guide in the battery compartment).
Ensure the batteries are inserted so that the flat ends are making contact
with the springs.
3. To close, replace the cover and turn clockwise.
Operation
Pull the string to turn on. Pull the string again to turn the light off.
Light Installation
Determine mounting location with adequate space for the string to hang.
You can shorten the string by pushing the tab towards the light to expose the
end of the string. Cut to your desired length, and tie a double stopper knot to
secure the tab.
Advertisement
Table of Contents
Related Manuals for WESTEK BL-PSTG
Summary of Contents for WESTEK BL-PSTG
- Page 1 BL-PSTG Pull-String Utility Light Owner’s Manual Battery Installation 1. To open, when looking at the back, twist the back cover counter-clockwise and remove. 2. Insert 4 AA batteries (follow the installation guide in the battery compartment). Ensure the batteries are inserted so that the flat ends are making contact with the springs.
- Page 2 Mounting with screws 1. Remove the back of the light by twisting counter clockwise. 2. Use the two holes in the back as a guide to drill pilot holes. 3. Secure the back to your mounting surface with included screws – do not overtighten.
Need help?
Do you have a question about the BL-PSTG and is the answer not in the manual?
Questions and answers