Pioneer RS-K1 Service Manual page 4

is-1 |
@Removing the Display Unit
1.While holding the tab of gear unit at locations
indicated by black arrow.(Fig.5)
2.Press the display unit at locations indicated by white
arrows. (Fig.5)
3.While holding down the lock button ,pull the display
unit toward you.(Fig.6)
Gear Unit
Fig.5
Display Unit
@Removing the Cover Unit
1.Remove the four screws.
2.Disconnect the four stoppers indicated by arrows.
3.Remove the cover unit.
Cover Unit
Fig.7
@Removing the Control P.C.Board
1.Disconnect the two connectors.
2.Remove the four screws.
3.Remove the solder,and then remove the control
P.C.board.
Solder
Fig.8
@Removing the Drive P.C.Board
1.Remove the three screws.
2.Remove the drive P.C.board.