Table of Contents
Advertisement
The operator is responsible for the safe operation of
the equipment. The operator must be properly trained.
Operators should be familiar with this equipment, the
tractor, and all safety practices before starting opera-
tion. Read the safety rules and safety decals on page 5
through page 9.
WARNING
■ Safety instructions are important! Read all
attachment and power unit manuals; follow
all safety rules and safety decal information.
(Replacement manuals and safety decals are
available from your dealer. To locate your near-
est dealer, check the Dealer Locator at www.
WoodsEquipment.com, or in the United States
and Canada call 1-800-319-6637.) Failure to fol-
low instructions or safety rules can result in
serious injury or death.
■ Never allow children or untrained persons to op-
erate equipment.
■ Power unit must be equipped with ROPS and
seat belt/operator restraint. Keep seat belt/
operator restraint securely fastened/engaged.
Falling off power unit can result in death from
being run over or crushed. Keep ROPS systems
in place at all times.
■ NEVER GO UNDERNEATH EQUIPMENT. Never
place any part of the body underneath equip-
ment or between moveable parts even when the
engine has been turned off. Hydraulic system
leak-down, hydraulic system failures, mechan-
ical failures, or movement of control levers can
cause equipment to drop or rotate unexpectedly
and cause severe injury or death.
•
Service work does not require going
underneath.
•
Read Operator's Manual for service in-
structions or have service performed by a
qualified dealer.
■ Do not allow bystanders in the area when op-
erating, attaching, removing, assembling, or
servicing equipment.
■ Before leaving operator's seat, lower lift arms
and put attachment on the ground. Engage
brake, stop engine, remove key, and remove
seat belt.
The Pallet Fork fits skid steer and front end loaders
with a universal mounting coupler (ISO 24410). Read
the skid steer or loader manual for instructions on prop-
er operation.
10 Operation
MAN1354_2024-01.indd 10
MAN1354_2024-01.indd 10
OPERATION
ATTACHING PALLET FORK TO LOADER
■ Be sure attachment is properly secured, adjust-
ed, and in good operating condition. Coupler
lockpins must be fully extended and properly
engaged into attachment retaining slots.
Read the loader operator's manual connecting and re-
moving instructions.
The loader coupler handles should be in the unlocked
position and the lockpins retracted (Figure 1).
Figure 1. Loader Coupler Handles - Unlocked
Move to the loader operator seat, fasten seat belt, en-
gage operator restraint, and start engine.
Lower loader lift arms to their lowest position.
Carefully move and align the loader coupler to the
Pallet Fork. The top of the loader coupler must index
into the Pallet Fork flange (Figure 2).
Roll the loader coupler into the Pallet Fork flange so
the coupler handles can be engaged.
ATTACHMENT
FLANGE
Figure 2. Attaching Pallet Fork to Loader
WARNING
HANDLES
UNLOCKED
LOCKPINS RETRACTED
LOADER
IL1335
COUPLER
IL1334
MAN1354
( 01/24/2024 )
1/24/24 12:37 PM
1/24/24 12:37 PM
Advertisement
Table of Contents
