Accessories - Champion LeakMaster NE240 Operation Manual

Accessories:

The following accessories are included with every LeakMaster NE240.
CEA-04
CEA-02
CEA-03
CEA-01
HS400AC
This EVAP Service Port Adapter is used when connecting
to a vehicle's Fuel Vapor Recovery System.
directly to the factory service access port on the vehicle.
The Cap Plugs Kit is used to seal the intake ducting of the
engine under test. These cap plugs range in size from 1 ¾" to
4 ½". They may be used to seal either the inside diameter of
an opening, or flip them over and seal the opening at the
outside diameter.
The Smoke Diffuser is an adapter designed to locate leaks
around doors, windows and sunroofs. The adapter allows the
operator to lay down a thick bed of smoke (from outside the
vehicle) along door seams, sunroof, windshield and windows in
order to watch for disturbance caused by unwanted airflow.
This rubber cone tapers in size from 1" to 3 ½" and has a
5/16" opening at the small end of the cone to which a short
section of hose is connected. The smoke supply nozzle is
inserted into the end of the hose to introduce smoke into any
system with an opening between 1" and 3 ½".
This cone is perfect for accessing the exhaust system of
automobiles and light trucks. It can also be used to access
radiators, water pumps or even seal the intake ducting while
filling the system through the cone adapter.
You can also use the cone to plug or seal the exhaust
system while testing the intake vacuum system.
achieved by plugging the hose leading from the cone with a
tapered plug provided. Plugging the exhaust pipe will prevent
smoke pressure loss through the tail pipe, in the event an
intake and exhaust valve are open in the same cylinder
This 25' Coilhose® is used to deliver Nitrogen to the EVAP
tester. Connect the
and the quick-disconnect fitting to the EVAP tester.
In addition, a halogen spotlight is provided. A bright light
source helps locate the smoke when looking for leak(s).
6
¼
pipe-thread to the Nitrogen regulator
It connects
This is