Table of Contents
Advertisement
Tester Overview:
Nitrogen / Air
Supply Hose
Smoke Supply Hose
Selector Switch
Flowmeter
Drain / Fill Plug
Nitrogen / Air Supply Hose; is used when performing the Phase-one test in order to confirm the
integrity of the system, or when verifying any system for leaks.
Smoke Supply Hose; is used to introduce diagnostic smoke into the system being tested for
leaks.
Selector Switch; selects the machine's Phase-one or Phase-two function.
Flowmeter; with its pointer-flag is used to establish a quick Pass / Fail when determining if the
vehicle being tested has a .040 or .020 leak.
Water Separator / Filter; assures a clean supply of Nitrogen or Air (located on back of tester).
Power Indicator Light; turns on when connecting the power leads to a battery, indicating good
contact.
Diagnostic Smoke Indicator Light; turns on after depressing the remote starter button,
indicating smoke production.
EVAP System Standards; are used to calibrate the flowmeter in order to perform the Phase-one
portion of the EVAP test.
Remote Starter & Power Cables; are used to operate the tester.
Drain / Fill Plug; used to drain and replace the smoke solution during the yearly maintenance
service (located on the outside-bottom of the tester).
Component Description
5
Water Separator / Filter
(Rear of Tester)
Power Indicator Light
Diagnostic Smoke
Indicator Light
EVAP System Standards
(& space for future Standard)
Remote Starter
& Power Cables
Advertisement
Table of Contents
