Transferring Data Between Memory Channels; Entering/Transferring Data In The Split Frequency Channels; A Memory Channel; Memory Recall - Trio TS-440S Instruction Manual

tained in the displayed memory channel.
4. Data in the VFO is replaced by the memory data.
Memory data is not lost during this operation.
3-6-3. Transferring data between memory channels
1. With the TS-440S/44X in the memory mode, press
the M.IN key and scroll to the channel that you
want the data to be transferred to.
2. Press the M.IN key. The frequency and mode of the
memory channel that appeared before you pressed
the M.IN key will duplicated in the new channel.
3-6-4. Entering/Transferring data in the split fre-
quency channels
Separate transmit and receive frequencies may be en-
tered into memory channels 90 through 99. The proce-
dure is similar to that given for the other channels with
the following exception:
1. The active VFO frequency and mode is stored in
the receive memory, and the inactive VFO frequen-
cy and mode is stored in the transmit memory,
regardless of whether the SPLIT function is ON or
OFF.
2. The RIT offset is stored in the receive memory, and
the XIT offset in the transmit memory.
3. When data is transferred from the general memory
section into the split frequency memory section the
transmit and receive frequencies will be the same.
4. Only the receive memory will be transferred into
general memory during transfer operations from the
split memory area.
3-6-5. Clearing a memory channel
Two methods may be used to clear a memory
channel:
1. M.IN switch
Transferring information from a vacant channel, i.e. one
that has no stored information, thru the use of the M.IN
switch, as described previously in section 3-6-1 is one
method of ''clearing'' a memory channel.
2. ENT switch
Data may also be erased by depressing the ENT key
while depressing the CLEAR key.
3-6-6. Memory recall
Fixed channel type recall is possible when using the
VFO/M key to recall memory channel information. The
stored frequency cannot be changed, although the
RIT/XIT function is active.
1. Press the VFO/M key. The memory channel num-
ber, mode, and stored frequency data will be dis-
played. If a channel contains no data, only the
channel number will be displayed.
>
Sd
"uu
LA
Bn
2. Select the desired memory channel using the
methods described under Memory Entry section.
Pee Sd
3. To return to the VFO mode, press the VFO/M key
again.
Notes:
1. RIT/XIT will be cancelled when the TS-440S/44X
is switched from the VFO mode to the memory
mode, but will be restored when the TS-440S/44X
returns to the VFO mode.
2. When the TS-440S/44X is switched from the
memory mode to the VFO mode, the VFO will be
set to the RIT/XIT variable specified when the data
was programmed in to memory.