Table of Contents
Advertisement
depressing this switch allows you to receive on the
transmit frequency as long as the switch is held
depressed. The TUNING
dial is active when this
switch is depressed, so it is easy to change your
transmitter frequency at the same time, if neces-
sary. Releasing the switch will return you to the
original receive frequency.
3-6. MEMORY
The TS-440S/44X
incorporates
a convenient
100
channel memory that can be used to store and recall
commonly used frequencies. These channels can be
subdivided into 10 user-defined groups to tailor the
TS-440S/44X for optimum operation in a particular ap-
plication. You can, for instance, assign channels
10
through
19 to the
160
meter
band,
channels
20
through 29 to the 80 meter band, channels 30 through
39 to the 40 meter band (LSB), channels 40 through
49 to the 20 meter band (USB), channels 50 through
59 to the
15 meter band, channels 60 to 69 to the 10
meter band (FM), channels 70 through 79 to the 12
meter band, and channels 80 through 89 to various
shortwave bands. Channels 90 through 99 could then
be assigned as split frequency channels. After com-
pleting channel assignments, you can then use the con-
venient memory scan function to automatically recall
the stored frequencies on a group basis.
3-6-1.
Memory Entry
1. With the TS-440S/44X in the VFO mode, select the
desired operating frequency and mode as described
in previous sections.
2. Press the M.IN switch. The radio will enter the
Memory Scroll (M.SCR) mode. The current memory
channel number (M.CH), frequency and mode will
be displayed, but the actual operating frequency
and mode will remain unchanged allowing uninter-
rupted reception.
M CH
[E
o
16
b. Enter a two digit channel number using the nu-
meric keypad, being sure to include the leading
zero for channels OO through 09. Pressing the
CLEAR key or the standby switch before press-
ing the second digit will return you to the origi-
nal channel.
c. Use the UP/DOWN switches and/or microphone
UP/DOWN switches to scroll thru the different
memory positions.
5. When the desired memory channel is displayed,
press the M.IN key again. The current frequency
and mode will be stored, the scroll:mode will be
cancelled, and the TS-440S/44X will return to the
operating mode and frequency that was displayed
before the M.IN key was pressed initially. Note that
if RIT was selected prior to step 2, the actual fre-
quency stored will be the indicated frequency plus
or minus the RIT variable.
3-6-2.
Transferring memory information to the VFO.
1. Press the VFO/M key to select the memory mode.
2. Select a channel using any of the methods dis-
cussed under the Memory Entry section.
20
ann
agung
Notes:
1. The RIT/XIT status will be copied from the memory
to the VFO when the MV
key is depressed.
2. When data is transferred from the split frequency
memory, the active VFO is loaded with the receive
data and the inactive VFO will be loaded with the
transmit data. The TS-440S/44X will then automat-
ically enter the SPLIT mode.
3. This operation will not function if no data is con-
Advertisement
Table of Contents
