Table of Contents
Advertisement
STEP 3:
1. Fasten the upper segment line (E03) and lower segment line (E04) as shown in the figure, then use
the Allen wrench (B17) 2-in-1 screw (D12*4) to fix the electronic meter group (F) to the instrument tube
group (A02) and lock it.
Caution: Be careful not to clip the wire!
2. Use a cross wrench (B18) and left pedal (C50) to fix it on the left crank (B01) in counterclockwise turn.
Ensure it is fully tightened.
3. Use a cross wrench (B18) with right pedal (C51) to fix it on the right crank (B02) in clockwise turn.
Ensure it is fully tightened.
Caution: Be careful not to cross thread the pedals and fully tighten before use. On the right side is a
clockwise turn and on the left side is a counterclockwise turn.
4. Fasten the front foot cover (C34) on the front foot pad fixing tube group (B) and use a cross wrench
(B17) and screw (D08*1) to fix it on the front foot pad fixing tube group (B) and tighten.
ASSEMBLY INSTRUCTIONS |
9
Advertisement
Table of Contents
