Safety Measures And Precautions For Use - Varia VS3 User Manual

Grind different
Hide thumbs Also See for VS3:
Table of Contents

Advertisement

USER MANUAL

1. Safety Measures and Precautions for use

Please take time to familiarise yourself with the
Varia VS3 safety measures and operational
guidelines detailed within this manual before
operating the grinder.
PLEASE NOTE the Varia VS3 Grinder incorporates high-speed rotating burrs
which are very sharp and have potential to cause personal injury if any of
the following safety measures / precautions or operating instructions
1.
PLEASE CHECK that your
operating power supply and
plug outlet type is compatible
with the Varia VS3 purchased.
2.
ENSURE your Varia VS3 body,
power adaptor and power cord
is placed in a dry situation, free
from any potential water/liquid
situations or any heat sources.
3.
BE AWARE that the grinding
burrs are very sharp, take extra
care when cleaning, servicing or
removing this part. See section
5. 'Cleaning and maintenance'
for detailed instructions. If
removed never leave a burr set
unattended on a bench, always
store securely out of reach of
children and within a securely
sealed protective container.
4.
Ensure the finger guard is firmly
in place within the bean hopper
prior to operating.
5.
DO NOT put your fingers into
the hopper when the motor
is running or when the power
supply is plugged in.
04
are ignored.
6.
ONLY operate with the hopper in
place. Exposed burrs can cause
injury to fingers, even if burrs are
stationary.
7.
NEVER allow long hair or loose
clothing near the burr housing.
8.
DO NOT attempt to clean burrs
while the grinder is switched on
or operational.
9.
If cleaning with a vacuum
cleaner, please remove the 4 x
springs below outer burr.
10. Coffee Beans may contain
foreign objects – eg. stones,
pebbles. Always check your
supply for any foreign objects
before grinding.
11. DO NOT attempt to grind pre-
ground coffee.
12. Varia VS3 is designed for
home use, not for continuous
commercial use.
13. DO NOT grind for more than
60 seconds in a single grinding
cycle, ensure a minimum of 90
seconds rest between grinding
cycles.

Advertisement

Table of Contents
loading

Table of Contents