Advertisement
Warning!
•
Do not use the device in small rooms with persons present who are not able to leave the room
on their own and are not supervised continuously.
•
Certain components of the device can become very hot and cause burns. Pay special attention
in case children or needy persons are present.
•
It is dangerous to install the device near curtains and other flammable materials. To avoid burns,
the following persons should be very careful when using the device: babies and children, per-
sons with sensitive skin, old persons, sick persons, persons being under the influence of alcohol
or medicine.
•
Remove the protective film (on the front part) before use.
•
Make sure that the input voltage is comprised between 220–240 V, 50 Hz and that the power
supply is made according to the regulations. Make sure that the left wire is zero and the right
one life and that the device is well earthed.
•
The devices consume more energy than small electric devices; therefore, a separate 10 A+
socket is required.
•
Do not operate this device in areas exposed to explosion hazards.
•
Install the device in an upright and stable position.
•
Let the device dry off after cleaning it with a damp material. Do not operate it as long as it is
wet.
•
Do not use the device with your hands being damp or wet.
•
Do not expose the device to direct water splashes.
•
Do not insert objects or parts of your body into the device.
•
Do not cover the device nor transport it during operation.
•
Do not sit on the device.
•
This product is not a toy! Keep children and animals away. Do not leave the device unsupervised
during its operation.
•
Check all accessories and connection parts before every use to know if they are intact. Do not
use the device if it has damaged parts.
•
Make sure that all electric cables outside the device are protected against damages (e.g.,
caused by animals). Do not use the device if electric cables or the electric connection are dam-
aged!
•
The electric connection must meet the indications of the section "Technical data."
•
Only plug the mains plug into a socket that is correctly earthed.
•
Do not use the device if the socket or cable are overcharged.
•
When using an extension cable, keep in mind the power consumption of the device, the length
of the cable, and the intended purpose. Completely unroll the extension cable and avoid electric
overcharges.
•
Before performing maintenance, care, or repair of the device, unplug the plug. Do not pull the
power cable to unplug the plug from the power socket.
•
Switch the device off and pull the plug out of the socket when the device is not in use.
•
Never use the device if you detect damages to the plug or cable. If the cable is damaged, a
qualified person must replace it to avoid any danger. Damaged cables cause serious risks.
•
When installing the device, respect the minimum distances to the wall and other objects and the
conditions of operation as stated in the "Technical data" section.
•
Never drill into the heating panel.
•
Do not use the device in direct proximity to curtains.
•
Do not place the device on a flammable surface.
•
During operation, do not touch the surface of the device to avoid burns.
•
Before transporting and/or inspecting the device, wait for it to cool down.
•
Do not use the device near bathtubs, showers, swimming pools, or water tanks. There is the
risk of an electric shock!
•
The device must be installed so that persons in a bathtub or under a shower cannot touch any
switch of regulator.
•
Heating panels installed to a wall must be at a height of more than 0.6 m.
•
Heating panels installed to a ceiling must be at a height of more than 1.8 m.
© by WilTec Wildanger Technik GmbH
http://www.wiltec.de
Item 64390–64396
Page 4
07 2023-1
Advertisement
