Advertisement
Installation
Before Installation
If the device is generally DC receiving and does not support POE
function, you can easily use POE-PD04S-12V to accept POE source
power and apply it separately from the DC output power. Using the DC
to DC cable which bundle in the package.
Cables Installation
POE-PD04S-12V provides a POE-powered solution for non-IEEE
802.3af/at devices.
The setup of the splitter can be performed using the following steps:
Connect from "DATA OUT" of POE-PD04S-12V to the RJ-45 port
of the remote device.
Make sure first power source that the POWER+DATA in Port of
the splitter is fully connected to the 802.3at source-powered
PoE Injector or PoE Switch.
Connect the correct DC plug from "DC OUT" of POE-PD04S-12V
to the DC port of remote device. (Use a DC cable to connect
devices that are to be powered by DC)
Caution: Please ensure the output voltage is correct for
remote device. Otherwise it will damage your remote
device.
Power on the remote device and the LED for voltage status
indicator on POE-PD04S-12V will remains on.
Installation
This device can be locked on the wall, (You can use the screw
set which pack with product) or it can be put on desktop.
LED Indicator :
Power
Yellow
Green (802.3at)
PoE
Off (802.3af)
Product Specifications
Standards & Hardware Specifications
IEEE 802.3 10BASE-T
IEEE 802.3u 100BASE-TX
IEEE 802.3ab 1000BASE-T
Standard
IEEE 802.3bz 2500/5000BASE-T
IEEE 802.3af Power over Ethernet (PoE)
IEEE 802.3at Power over Ethernet (PoE+)
10BASE –T: UTP Cat. 3 or up
Network Media
100BASE-TX: UTP Cat. 5 or up
1G/2.5G/5GBASE-T: UTP Cat.5e or up
10M/100M/1G/2.5G/5G (Half-duplex),
Data Transfer Rate
20M/200M/2G/5G/10G (Full-duplex)
Data PIN
PIN 1/2, 3/6 & 4/5, 7/8
End-span (Type-A): PIN 1/2,3/6 ;
Power PIN
Mid-span (Type-B): PIN 4/5,7/8
Data In
Connects PC/HUB/Switch
RJ-45 x1 for Power + Data input
Ethernet Connector
RJ-45 x1 for Data output
ESD electrostatic discharge protection and
ESD Protection
load discharge anti-surge design
Environmental & Mechanical Characteristics
Max Power
27Watts
Output
DC-Jack : Output to any none PoE 12V DC in
Power Interface
device
Power Requirement
802.3af/at PoE Power Source
PoE Input Voltage
44V~57V
DC Output
12V
DC Output Current
Max 2.25A
Power: Yellow
LED Indicators
PoE: Green (802.3at) , Off (802.3af)
Operating
0° to 55° C
Temperature
Storage
-40° to 70° C
Temperature
Operating Humidity
10% to 90% non-condensing
Storage Humidity
5% to 90% non-condensing
Dimension
111 x 79 x 35.5mm ( W x D x H )
Unit Weight
203g
Case of Materials
Metal
Production Location
TW
Certification
FCC, CE, RoHS compatible
v1.0
Advertisement
