Advertisement
VMC-180E 04.10.8 7:04 PM ページ 9
REAR PANEL SECTION
37
30
31
39
POWER SWITCH
#0
Use to turn power on
#1
POWER INPUT JACK
Connect the Vestax AC-12A, AC adaptor (12V
AC, 1000mA).
#2
GROUND TERMINAL
Connect this terminal to the ground lead of the
turntables.
#3
PHONO INPUT JACK [RCA PIN JACK]
Connect turntables equipped with MM (Moving
Magnet type) cartridge. The signal from the
turntable is fed to the PGM channels when Phono
input is selected.
LINE INPUT JACK [RCA PIN JACK]
#4
Connect the equipment with line level output (-
10dB or 0dB), such as CD players, tape decks,
DATs, MDs, etc. The signal from line level
equipment is fed to the PGM channels when Line
input is selected.
#5
AUX RECEIVE JACK
Connect to the output of the external effects
38
36
34
35
33
32
#6
AUX SEND JACK
Connect to the input of the external effects.
(Delay, Reverb etc)
#7
MASTER 1 OUTPUT JACK [BALANCED XLR
JACK:PIN2-HOT]
Connect to the input of power amp
MASTER 1 OUTPUT JACK [RCA PIN JACK]
#8
The MASTER 1 jack is an unbalanced RCA
output. The signal is same with master.
MASTER 2 OUTPUT JACK [UNBALANCED
#9
PHONE JACK]
Connect to input of power amp as monitor in DJ
booth or as a separate sound zone for entrance
foyer etc.
-8-
HOW TO CHANGE THE FADER UNIT
HOW TO CHANGE THE INPUT FADER UNIT
Notes
・ Please match the size of the screwdriver to the
screw.
Using a wrong screwdriver may damage the
screw.
・ DO NOT touch the PCB board that is set on the
rear of the cover.It may cause damage.
■change to "IF-180"
①Remove the fader knobs. (see fig-a)
Notes
When the unit is placed upside down, the knobs
may be pushed down and damage the pot.
Please apply soft material (babble pack, etc.)
under the unit and mind not to give pressure to
the knobs
②Remove the bottom cover. (see fig-b)
③Remove the 4 screws which fix the input fader unit, and
remove the fader unit from position in mixer. (see fig-c)
④Carefully remove the multi-cable connector from the
fader unit. (see fig-d)
⑤Attach multi-cable connector to new fader uni.
Notes
When reattaching or replacing an input fader
please ensure that the fader is connected
properly. When correctly attached the" "on the
input fader will be pointing towards the rear
panel and the label on the connector will match
up to that input fader.
IE:"PGM1" "PGM2" "SUB"
⑥Position the fader unit carefully and secure with screws.
fig.a
fig.b
CUSHION
fig.c
fig.d
-9-
Advertisement
