EN Digital blood pressure monitor Important safety instructions READ CAREFULLY AND STORE FOR FUTURE USE. GENERAL WARNINGS • Prior to using this device, please read the user's manual thoroughly, even in cases, when one has already familiarised themselves with previous use of similar types of devices.
• Do not use this device if your are receiving intravenous nutrition or a blood transfusion. Do not use this device in locations where high-frequency (HF) surgical equipment, magnetic resonance imaging (MRI) equipment or computer tomography (CT) scanners are present. This could result in the incorrect function of the device or in incorrect measurements.
ELECTRICAL SAFETY • Use a standard AAA-type batteries. When replacing the batteries, adhere to the marked polarity. When not using the blood pressure monitor for an extended period of time, remove the batteries out of it. • In the event that there are visible signs of corrosion on any of the batteries or electrolyte is leaking out, replace it immediately, otherwise the blood pressure monitor may be damaged.
Page 9
Manufacturer: Shenzhen AOJ Medical Technology Co., Ltd. Room 301&4F, Block A, Building A, Jingfa Intelligent Manufacturing Park, Xiaweiyuan, Gushu Community, Xixiang Street, Bao’an District, 518126 Shenzhen, CHINA Date of manufacture: Serial number Batch number Authorised for the EU: Share Info GmbH Heerdter Lohweg 83, 40549 Düsseldorf, Germany Unique product identifier.
............INTRODUCTION • Thank you for purchasing a SENCOR brand product and we hope that you will be happy with it.
Page 11
Note: Note: Do not worry if you have measured an abnormal blood Always replace the battery when: pressure values. Blood pressure can be better assessed - the display is dim or hard to read individually after 2 or 3 measurements performed always - the display does not turn on at the same time of day over a longer time period.
• Do not perform measurements in an excessively cold environment. • Press the START/STOP button. The display will momentarily show all the symbols and then 00 will appear. • Take the pressure measurement on a naked arm while sitting in the upright position.
Attention: The measurement result is abnormal. Relax for a few In the event that it is not possible to measure the moments. Put the cuff back on and repeat the measu- Er 3 blood pressure even after trying all the above rement.
TECHNICAL SPECIFICATIONS THE DIRECTIVE AND STATEMENT OF THE MANUFACTURER – RESISTANCE AGAINST ELECTROMAGNETIC INTERFERENCE Power source ..4× 1.5 V AAA-type batteries; optional 5 V power adapter, USB-C connector • This arm cuff blood pressure monitor is intended for use in the Display ..................
Page 15
THE DIRECTIVE AND STATEMENT OF THE MANUFACTURER – RESISTANCE AGAINST ELECTROMAGNETIC INTERFERENCE • This arm cuff blood pressure monitor is intended for use in the electromagnetic environment described below. The customer or user of this arm cuff blood pressure monitor must ensure that it is used in such an environment. High-frequency radiation (HF) RF0-4-3 (Test specifications of RESISTANCE TO EMISSIONS VIA THE COVER OF THE DEVICE against HF wireless communications equipment) Test frequency...
Note: The optional power adapter must meet the requirements of norm IEC 60601-1. Use only the power adapter specified by an authorised vendor. Other adapters may differ in their output voltage and polarity and may present a risk to your life or damage of this device.
Page 17
FAST ČR, a.s. U Sanitasu 1621 CZ-251 01 Říčany www.sencor.eu...