Advertisement
Installation
1. Fit Tap Body (1) to bath, ensuring that the Washer (2) is fitted between the Tap
Body (1) and the bath.
2. Fit Anti-Rotational Washer (3) over inlet legs. Then fit Backnuts (4) to the inlet
legs and tighten. DO NOT OVERTIGHTEN.
3. Connect to the water supply using suitable plumbing joints.
4. Fix Shower Hose (6) to Tap Body (1) using the Rubber Washer supplied with the
shower hose. Rubber Washer to be fitted between the Shower Hose (6) and the
Tap Body (1). DO NOT OVER TIGHTEN.
5. Fix Wall Bracket (5) to the wall at the required height ensuring the Handset (7)
will fit correctly into the Wall Bracket (5).
6. Turn on the hot and cold and mains water supply. Check for leaks
immediately. It is always advisable at this stage to flush out the system.
To do this, open both valves fully and allow water to flow for approx.1
minute. This will remove any foreign matter
within the installation.
7. Finally turn on all the water heating
arrangements.
8. Assemble Shower Hose (6) to Handset (7)
using Rubber Washer supplied with
Shower Hose (6).
DO NOT OVERTIGHTEN.
Aftercare
Whilst modern plating techniques are used in the manufacture of these fittings, the
plating will wear if not cleaned properly. The safest way to clean your product is
to wipe with a soft damp cloth. Stains can be removed using washing up liquid.
All cleaning powders and liquids will damage the surface of your fitting even the
non-scratch cleaners.
4
1
2
3
4
7
6
5
INST NM05 (Rev.1.1)
Advertisement
