Tvf Modulation - Roland D-50 Owner's Manual

TONE PARAMETERS
@ Level 2
This sets the level of point 2 from 0 to 100.
@Time 3
This sets the time needed to reach point 3 from point 2. 0 to
100 are valid.
@level 3 MOR ay
This sets the level of point 3 from 0 to 100.
@Time 4 EONS
This sets the time needed to reach point 4 from point 3. 0 to
100 are valid.
@ Sustain Level RRUERGY
This sets the level of point 4 from 0 to 100.
@Time 5 RUE GY
This sets the time needed to reach point 5 from the moment the
key is released. 0 to 100 are valid.
@End Level
To lower the level after releasing the key, set this to 0, and to
raise the level, set it to 100.
*The End Level is retained unti! you release and play the key again.
*If the Levels of two adjacent points are set to similar values, the time
between these two points may prove to be shorter than what is
actually set, or even zero.
g. TVF Modulation
[Display 34]
Streai iiii Farth-i TUF Mod
B LFODiae ALR?
an oe
LFO Select LFO Depth Aftertouch Range
@LFO Select IER 2
This selects the LFO that changes the cutoff point periodically
(creating growl effects).
42