Table of Contents
Advertisement
FIGURE 7.
\\u\
FIGURE 8.
INSTALLING THE BATTERY
(Hardware
C)
1. Open the hood of the lawn tractor by lifting up on
both sides of the hood.
2. Attach one push nut to each battery hold-down rod.
-See figure 6, inset. Hook one hold-down rod into
the holes in the battery plate which will be on each
end of the battery. Slide the push nut down the rod,
against the battery plate.
3. Place the battery in the awn tractor so that the
positive terminal is facing the right side of the unit.
See figure 6.
NOTE: Right and left hand sides of the unit are deter¬
mined from the operating position, facing forward.
4. Slide the hex nut (provided with battery hardware)
into the positive ( + ) terminal. Place the positive
cable on the positive terminal. Secure with bolt pro¬
vided. See figure 6.
5. Slide the hex nut (provided with battery hardware)
into the negative (-) terminal. Place the negative
cable on the negative terminal. Secure with bolt
provided.
6. Place the black plastic battery cover in position
over the hold-down rods. Secure with wing nuts.
— See figure 7.
7. Route the battery drain tube down beside the
engine, then forward to the hole in the frame shown
— in figure 8. Insert end of drain tube through the hole
in the frame.
9
Advertisement
Table of Contents
