Table of Contents
Advertisement
7. Disconnect the stabilizer plate from the stabilizer
shaft assembly by removing the hairpin clips and
flat washers and sliding out the rod.
8. Place the lift lever in the disengaged position.
9. Slide the deck from beneath the lawn tractor.
10. Remove the belt guards at each deck pulley by
removing the self-tapping screws. See figure 21.
FIGURE 21.
11. Remove and replace the belt, reassemble follow¬
ing the instructions in reverse order.
REAR DRIVE BELT
1. Place shift lever in neutral position. Unscrew the
shift knob. Remove the two truss head screws
which secure the transmission cover. See fiqure
22 A.
2. Lift the transmission cover. Unplug the safety wire
from beneath the transmission cover. See figure
22B. Remove transmission cover.
3. Push the idler pulley toward the right side of the
unit. Lift the belt over the idler pulley. See figure 23.
4. Remove the belt from the variable speed pulley.
5. Remove the two bolts which hold the shift lever
bracket to the frame on the left side of the unit.
Swing the bracket toward the right so the belt can
be removed from the transmission pulley. See
figure 23
6. Replace belt, and reassemble in reverse order.
FRONT DRIVE BELT
1. To remove the front drive belt, first remove the rear
drive belt from the idler pulley and variable speed
pulley.
2. Place the lift lever in the disengaged position.
3. Remove the three hex bolts (belt keepers) from the
engine pulley belt guard. Refer to figure 20.
4. Unhook the deck belt from the engine pulley.
5. Remove the two bolts, lock washers and nuts on
each side of the frame which hold the engine pulley
belt guard to the frame. See figure 24.
FIGURE 24.
18
Advertisement
Table of Contents
