Advanced Functions; Troubleshooting Chart - Sharp PS-935 Operation Manual

Advanced functions

Bluetooth operation
■
1.
Press the INPUT / STAND-BY button on the unit
to switch to the BLUETOOTH function. "
will be blinking on the display.
2.
Turn on the Bluetooth function on the source
device, scan the unit "PS-935 SHARP" and
connect, then input the password 0000 if
required. The display will stop blinking once the
connection is made.
3.
Rotate the VOLUME knob on the unit or adjust
the volume on the source device to increase
or decrease the music volume to your desired
level.
4.
To skip up or down a track, press the
button.
5.
To pause playback, press the
again to resume playback.
6.
To disconnect Bluetooth, press and hold the
button until "disconnected" voice prompt is
heard.
Note:
Bluetooth works best within 32 feet (10 meters) in
open air.
AUDIO IN (Auxiliary input) operation
■
1.
Press the INPUT/STAND-BY button repeatedly
until " " is displayed.
2.
Connect your audio device to the AUDIO IN
terminal on the top panel of the unit with an
audio cable (audio cable is not included).
3.
Rotate the VOLUME knob on the unit or adjust
the volume on the external device to increase
or decrease the music volume to your desired
level.
4.
Control the playback with your audio device.
MIC operation
■
Microphone input is available in all modes.
1.
Connect your microphone to the 6.3mm MIC
terminal located on the top panel of the unit.
2.
Rotate the MIC VOL +/- knob on the unit to
increase or decrease the microphone volume.
3.
Rotate the ECHO knob to turn on or off the echo
effect of the microphone.
PS935_IM_EN.indd 13 PS935_IM_EN.indd 13

Troubleshooting chart

General
■
Symptom
"
●
No sound is
heard.
●
Noise is
heard during
playback.
●
The power is
not turned on.
or
button. Press
Bluetooth
■
Symptom
●
No sound is
heard.
●
Bluetooth
sound is
interrupted or
distorted.
USB
■
Symptom
●
Device cannot
be detected.
●
Playback does
not start.
●
Wrong time
display.
E-13
Possible cause
●
The input signal
(selection) is not set
properly.
●
The volume level is set
to "00".
●
Muting is activated at
external device.
●
Move the speaker away
from any computers or
mobile phones.
●
The unit has not enough
battery power.
●
The protection circuit may
be activated. Switch off
and on the unit again.
●
Battery is completely
depleted. Recharge the
battery.
Possible cause
●
The unit is too far from
the Bluetooth audio
source device.
●
The unit is not paired
with the Bluetooth audio
source device
●
The unit is too near to
a device that generates
electromagnetic radiation.
●
There is an obstacle
between the unit and the
Bluetooth audio source
device.
Possible cause
●
There is no MP3 file
inside the device.
●
The device is not properly
connected.
●
It is an MTP device.
●
The device contains AAC
file only.
●
A false MP3 file is being
played back.
●
A Variable Bitrate files are
being played back.
6/26/23 4:19 PM 6/26/23 4:19 PM